Re: [arch-general] ip addr show doesn't show my ipv4 address after update, is this expected behaviour?

6 Aug 2012

      On 6 August 2012 12:50, Karol Blazewicz <karol.blazewicz@gmail.com> wrote:
...
$ ip -4 addr
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN
    inet 127.0.0.1/8 scope host lo
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast
state UP qlen 1000
    inet 192.168.1.2/24 brd 192.168.1.255 scope global eth0
Read the man page for other options.
Sure that these options works, but the previous behaviour which:
1. was shorter to write
2. allowed to inspect both IPv6 and IPv4
was much better IMO.

The man page only adds confusion, as it says: "ip falls back to the
default one, usually inet or any" when no family was specified and it
cannot be guessed from arguments.

Re: [arch-general] ip addr show doesn't show my ipv4 address after update, is this expected behaviour?

Lukas Jirkovsky