I'm having problems getting my wireless connection to work properly. It's a broadcom card, using the b43 driver. It connects fine on login, but once I actually use the network I'm disconnected and all attempts to re-connect fail. I've found some reports of similar behaviour online, but none seem to offer any good solutions to it :-( So I'm trying my luck in here instead. One person mentioned that things started working much better if he limited the network to 802.11b (not g), but I haven't seen any obvious way of achieving this. Any hints on what I can do to test that myself? $ lspci -vnn |grep 14e4 03:00.0 Network controller [0280]: Broadcom Corporation BCM4312 802.11b/g [14e4:4315] (rev 01) I did extract some stuff from dmesg that might be of importance, but I really couldn't tell: b43 ssb0:0: firmware: requesting b43/ucode15.fw b43 ssb0:0: firmware: requesting b43/lp0initvals15.fw b43 ssb0:0: firmware: requesting b43/lp0bsinitvals15.fw b43-phy0: Loading firmware version 478.104 (2008-07-01 00:50:23) b43-phy0 ERROR: Fatal DMA error: 0x00000800, 0x00000000, 0x00000000, 0x00000000, 0x00000000, 0x00000000 b43-phy0 ERROR: This device does not support DMA on your system. Please use PIO instead. b43-phy0: Controller RESET (DMA error) ... b43-phy0: Loading firmware version 478.104 (2008-07-01 00:50:23) b43-phy0: Controller restarted Cheers, M -- Magnus Therning (OpenPGP: 0xAB4DFBA4) magnus＠therning．org Jabber: magnus＠therning．org http://therning.org/magnus identi.ca|twitter: magthe