I'm having a problem getting dialup to work... Due to financial limitations, I'm going to have to give up my expensive broadband connection in favor of {sigh} dial-up which will save me about $50/month. I still have my external v92 zoom serial modem from before I went broadband. But now that my only working computer is my laptop I had the problem of not having a serial port to connect it to. I already tried to get my laptops internal {win}modem to work via Linmodem, but failed miserably... Thus I acquired a usb/serial adapter cable, and used it to connect my v92 modem. wvdialconf detected it OK. But I can't get it to dial. With some experimentation based on some init strings I found online and a brief modem command reference, I've been able to get the modem to at least go off hook, by adding H1 to the Init2 string. Proving at least that wvdial was attempting to control the correct device. But it didn't dial. It complained that my dial string was invalid and disconnected... Except that the modem didn't hang up (I listened to the phone company recording about hanging up and dialing again...) A little more experimentation reveled that if I used &C0 instead of &C1 it would hang up when it disconnects. But it still doesn't actually dial. And still complains about my dial string. I have verified the 7 digit 'Phone = "7340102" ' string by manually dialing it with a telephone and heard the sound of my ISP's modem attempting to negotiate a connection. And, in my wvdial.conf, I have tried the string both with and without quotes. I've included {below} a copy of my wvdial.conf & pasted in the results of my last attempt to use wvdial... Could somebody tell me what I'm doing wrong? => My wvdial.conf (with password line modified of course): [Dialer Defaults] Init1 = ATZ # Init2 as defined by wvdial.conf: # Init2 = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0 # Init2 modified: Without H1 stayed on hook. Without &C0 wouldn't hang up on disconnect... Init2 = ATQ0 V1 E1 S0=0 &C0 &D2 H1 +FCLASS=0 Modem Type = Analog Modem Modem = /dev/ttyUSB0 Baud = 115200 New PPPD = yes # tried with and without Carrier Check Carrier Check = off # tried with and without Stupid Mode Stupid Mode = on Dial Command = ATDT Phone = "7340102" ISDN = 0 Username = jtwdyp@ttlc.net Password = xxxxxxxxxxxxxxx => A screen capture of my last wvdial attempt: UnderTree =-> wvdial --> WvDial: Internet dialer version 1.61 --> Cannot get information for serial port. --> Initializing modem. --> Sending: ATZ ATZ OK --> Sending: ATQ0 V1 E1 S0=0 &C0 &D2 H1 +FCLASS=0 ATQ0 V1 E1 S0=0 &C0 &D2 H1 +FCLASS=0 OK --> Modem initialized. --> Sending: ATDT7340102 --> Waiting for carrier. ATDT7340102 ERROR --> Invalid dial command. --> Disconnecting at Thu Jun 3 15:38:23 2010 UnderTree =->