Hi all, I have a Dell Latitude E6430 shipped with this Nvidia device: 01:00.0 VGA compatible controller: NVIDIA Corporation GF108GLM [NVS 5200M] (rev a1) (prog-if 00 [VGA controller]) Subsystem: Dell Device 1534 Flags: bus master, fast devsel, latency 0, IRQ 44 Memory at f5000000 (32-bit, non-prefetchable) [size=16M] Memory at e0000000 (64-bit, prefetchable) [size=256M] Memory at f0000000 (64-bit, prefetchable) [size=32M] I/O ports at e000 [size=128] Expansion ROM at f6000000 [disabled] [size=512K] Capabilities: [60] Power Management version 3 Capabilities: [68] MSI: Enable+ Count=1/1 Maskable- 64bit+ Capabilities: [78] Express Endpoint, MSI 00 Capabilities: [b4] Vendor Specific Information: Len=14 <?> Capabilities: [100] Virtual Channel Capabilities: [128] Power Budgeting <?> Capabilities: [600] Vendor Specific Information: ID=0001 Rev=1 Len=024 <?> Kernel driver in use: nouveau My Laptop has VGA and HDMI output, both are used inorder to get a triple display system: on board screen + one on VGA, one on HDMI. Do you have special recommandation on which driver to install and any tip relative to that hardware? Note: Currently using Fedora it works quite well, but I really want to give a try to ARch and want to get my screens as soon as possible :-) Thanks for your help.