All, I'm a bit confused with a connection refused from the X-server attempting to start fluxbox within an Arch guest. I don't know if I'm doing something wrong or if I have a module problem after the last kernel update. (dkms says everything was rebuilt) I have the following installed: virtualbox-bin 5.1.8-1 virtualbox-ext-oracle 5.1.8-1 on 4.8.12-3-ARCH I start virtualbox headless $ VBoxManage startvm "arch_1_64" --type headless and then connect to the vm with rdesktop, e.g. $ rdesktop fenrir -u david -g 1280x800 -x l & The connection to the guest is fine, it pops up with the 1152x864 framebuffer resolution I set. If I start it without 'headless', the console starts over ssh and mouse-pointer integration is automatic, just as it should be. But either way, if I attempt to start x, via 'startx' as I do normally with my `.xinitrc` set to launch fluxbox, I get: xinit: unable to connect to X server: Connection refused. The host modules loaded are: 10:58 fenrir:~/cnf/vbox> lsmod | grep box vboxnetflt 28672 0 vboxnetadp 28672 0 vboxpci 24576 0 vboxdrv 385024 4 vboxnetadp,vboxnetflt,vboxpci which I don't see a vboxvideo or vboxsfs, etc.., but that is where my confusion comes in. Since this is 5.1.8 (well after 5.0.8 as mentioned in the wiki) are those modules even used anymore? and if not, do I have all the modules I need? Checking the Xorg.0.log on the guest it complains it can't find 'vboxvideo', 'fbdev' or 'vesa' modules, e.g. 'no screens found(EE)'. Do I need to do something more in the guest after upgrading the kernel there? -- David C. Rankin, J.D.,P.E.