On Fri, Oct 1, 2021 at 12:02 PM Mike Cloaked wrote:

On Fri, Oct 1, 2021 at 2:24 AM Adriel Cardenas via arch-general < arch-general@lists.archlinux.org> wrote:

...

Hi everyone,

I am trying to set up a MFP 125a (all in one HP device), and usually just installing CUPS + HPLIP detects and configure this kind of devices, however in this case I am able to use the printer but not the scanner.

Have you tried setting up the printer and scanner with driverless printing and scanning? I have an HP printer, and setting it up driverless means there is no need to use the HPLIP package at all and it sets up a single ppd file, and works well in general. Although I don't have a scanner the arch wiki has advice on setting up driverless scanning too at https://wiki.archlinux.org/title/SANE#Installation

That may lead to a solution?

It seems that the M125 is supported for driverless scanning according to the supported device list at https://github.com/alexpevzner/sane-airscan/ -- mike c

El 01/10/2021 6:02 am, Mike Cloaked via arch-general escribió:

On Fri, Oct 1, 2021 at 2:24 AM Adriel Cardenas via arch-general < arch-general@lists.archlinux.org> wrote:

...

Hi everyone,

I am trying to set up a MFP 125a (all in one HP device), and usually just installing CUPS + HPLIP detects and configure this kind of devices, however in this case I am able to use the printer but not the scanner. The printer it is detected correctly and works fine, but keep getting an I/O error whenever I try to use the scanner.

The device is recognized by lsusb like:

Bus 001 Device 005: ID 03F0:222a HP, Inc LaserJet Pro MFP M125nw

And scanimage -L and sane-find-scanner recognize it like:

device `hpaio:/usb/HP_LaserJet_Pro_MFP_M125a?serial=CNB6F0568K' is a Hewlett-Packard HP_LaserJet_Pro_MFP_M125a all-in-one

found USB scanner (vendor=0x03f0 [Hewlett-Packard], product=0x222a [HP LaserJet Pro MFP M125a]) at libusb:001:005

Doing a little research got here:

https://evilshit.wordpress.com/2012/09/23/how-to-install-and-configure-hp-pr... where indicates that uncommenting the #hpaio line in the /etc/sane.d/dll.conf would help, but it doesnt have that line :(

Does anyone have seen something like this? any good tips or links for settiing this AIO device?

uname -a: Linux archlinux 5.10.69-1-lts #1 SMP Sun, 26 Sep 2021 12:30:37 +0000 x86_64 GNU/LinuxP

Have you tried setting up the printer and scanner with driverless printing and scanning? I have an HP printer, and setting it up driverless means there is no need to use the HPLIP package at all and it sets up a single ppd file, and works well in general. Although I don't have a scanner the arch wiki has advice on setting up driverless scanning too at https://wiki.archlinux.org/title/SANE#Installation

That may lead to a solution?

Thanks, I did try that alternative first, besides the SANE configuration. Regards