Hi all, I've regularly used a VPN to access my school network. I use Juniper ncsvc to connect. It is worked into a script such that I can just call it, and then C-c to stop the VPN. Previously, the default route would be restored after I killed the VPN connection, so I could close the vpn connection and resume my internet use without thought. Now, I need to restart networkmanager (or that's the quickest/dumbest way I could mindlessly think of) to restore the connection (see output below). What has changed this behavior, and what methods can I take to getting the old behavior back? Thanks, MAQ. #Output #Note that echos indicate events that took place in another terminal $ route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface default 192.168.1.1 0.0.0.0 UG 0 0 0 wlan0 192.168.1.0 * 255.255.255.0 U 0 0 0 wlan0 $ echo "Start VPN" Start VPN $ route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface default 123.45.67.89 0.0.0.0 UG 1 0 0 tun0 default 192.168.1.1 0.0.0.0 UG 10 0 0 wlan0 vpn.school.edu 192.168.1.1 255.255.255.255 UGH 1 0 0 wlan0 192.168.1.0 123.45.67.89 255.255.255.0 UG 1 0 0 tun0 192.168.1.0 * 255.255.255.0 U 10 0 0 wlan0 192.168.1.1 * 255.255.255.255 UH 1 0 0 wlan0 $ echo "Stop VPN" Stop VPN $ route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.1.0 * 255.255.255.0 U 0 0 0 wlan0 $ echo "Restart networkmanager" Restart networkmanager $ route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.1.0 * 255.255.255.0 U 303 0 0 wlan0 $ route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface default 192.168.1.1 0.0.0.0 UG 0 0 0 wlan0 192.168.1.0 * 255.255.255.0 U 0 0 0 wlan0 $