[arch-general] Single Drive Fresh Install (mbr/grub2) Fails to boot (can boot existing from .iso??)

[Ralf Mardorf]

On Sat, 29 Oct 2016 13:01:42 +0200, Ralf Mardorf wrote:
>On Sat, 29 Oct 2016 05:48:29 -0500, David C. Rankin wrote:
>>Any other thoughts?  
>
>Store the BIOS settings, turn of the computer, remove the CMOS battery,
>set the jumpers to clear the CMOS RAM, wait a few seconds, set the
>jumper back, turn on the computer, do not restore the BIOS settings,
>perhaps it solved the issue. Then restore the BIOS settings ...
>
>*?*
>
>Regards,
>Ralf

PS: Don't use the same battery again, replace it by a new battery, or
at least measure the voltage of the old battery under load, e.g.
measure with a resistor parallel to the multimeter.