[arch-general] Fwd: Kernel panic - after upgrade

[Csányi Pál]

2015-01-30 21:10 GMT+01:00 Csányi Pál <csanyipal at gmail.com>:
> 2015-01-30 20:33 GMT+01:00 Christian Demsar <vixsomnis at fastmail.com>:
>> On January 30, 2015 2:21:34 PM EST, "Csányi Pál" <csanyipal at gmail.com> wrote:
>>>2015-01-30 20:04 GMT+01:00 Csányi Pál <csanyipal at gmail.com>:
>>>> Hi Damjan,
>>>>
>>>> 2015-01-30 19:39 GMT+01:00 Damjan Georgievski <gdamjan at gmail.com>:
>>>>>> I'm thinking now about following.
>>>>>> Whether to purge my Desktop Arch linux installation from hard disk
>>>and
>>>>>> install a fresh Arch linux again, or not?
>>>>>>
>>>>>> What would you do in my case? ( I'm not a bash and Arch linux guru.
>>>)
>>>>>
>>>>> First thing is, how did it happen to become broken again.
>>>>
>>>> If I could to know that.
>>>>
>>>>> Normally it shouldn't break by itself.
>>>>
>>>> I just update my system every day.
>>>
>>>I think it is broken somehow.
>>>Say, bash command starts and after a while freezes.
>>>Same in Midnight Commander.
>>
>> Your pacman log and journalctl might give some clues.
>>
>> Of course, I'm guilty of using the "throw-it-out" method, because the concept of a repaired system just doesn't compare to an unbroken one, even if they're identical...
>> --
>> vixsomnis
>
> In 'journalctl -e' I see these lines:
> jan 30 11:00:58 csparch org.a11y.Bus[4553]: Activating service
> name='org.a11y.atspi.Registry'
> jan 30 11:00:58 csparch org.a11y.Bus[4553]: Successfully activated
> service 'org.a11y.atspi.Registry'
> jan 30 11:00:58 csparch org.a11y.atspi.Registry[4719]: SpiRegistry
> daemon is running with well-known name - org.a11y..atspi.Registry
>
> Are these lines all right?

I suspect I have a virus mybe.

So I just installed clamav but when I'm trying to start it with:
'sudo systemctl start clamd.service'

I get:
Job for clamd.service failed. See "systemctl status clamd.service" and
"journalctl -xe" for details.

'systemctl status clamd.service'
 clamd.service - clamav daemon
   Loaded: loaded (/usr/lib/systemd/system/clamd.service; enabled;
vendor preset: disabled)
   Active: failed (Result: exit-code) since p 2015-01-30 21:14:04 CET; 10s ago
  Process: 9693 ExecStart=/usr/bin/clamd (code=exited, status=1/FAILURE)

Any advices will be appreciated.

-- 
Regards from Pal