[arch-general] Configure default bluetooth profile in PulseAudio?

[Uwe Sauter]

Unfortunately, configuring

/etc/pulse/default.pa
load-module module-bluetooth-policy auto_switch=2

has no effect on both PCs I tried. It seems that the browsers I'm using (Firefox & Opera) don't request an input stream 
which might trigger the BT profile change but iterate over existing devices, thus they don't see any input.

I'd really prefer a static configuration…

Regards,

	Uwe

Am 13.01.21 um 10:34 schrieb Ben Oliver via arch-general:
> I think auto-switching might not be so bad if it works as advertised.
> 
> With regards to your static configuration, pulse seems to remember your preferences pretty well.
> 
> I just ran youtube over my headphones and mpv over my speakers. (used pavucontrol to set it up)
> 
> Disconnected the headphones, everything went to speakers.
> 
> Reconnected the headphones, only youtube went back to them. mpv stayed on the speakers as before.
> 
> In this scenario, perhaps auto switching would work for you since your speakers should remain unaffected.